Vehicle Diagnostic Tester, Connecting, Bora/Golf MY 1998 Through 2003

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Vehicle Diagnostic Tester

Procedure

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- On vehicles with automatic transmissions, move the selector lever to the "P" or "N" position.

-- On vehicles with manual transmissions, move the shift lever to the neutral position.

-- Remove the trim panel -1- in the direction of the -arrow-.

Fig 1: Connecting Tester VAS 5051 To Data Link Connector Using Diagnosis Cable VAS 5051/1

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- With the ignition switched off, connect the Vehicle Diagnostic Tester to the vehicle diagnostic connection.

-- Turn on the ignition.

NOTE:

The method for connecting all other Vehicle Diagnostic Tester can be derived from the sequence described above.