LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Wiring - General Information (Convertible)) >> 97 Wiring >> Fiber-Optic Cable >> Fiber-Optic Cable, Disconnecting From Wiring Harness Connector >> Installing

Fiber-Optic Cable, Disconnecting From Wiring Harness Connector: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal. Note the following:

-- Install the fiber-optic cable according to the markings.

NOTE:

Push the corrugated tube into the connector housing until it audibly engages.

Seal open fiber-optic cable connector -2- with Fiber-Optic Repair Set - Connector Protective Caps VAS 6223/9 -item 1-.

Fig 1: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9
GWWA97-0760Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The protective cap prevents contamination of or mechanical damage to front surface of fiber optic cable which would impair signal transmission.