New Antenna Wire, Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Note that, depending on the vehicle equipment, the entire length of an antenna wire may be separated into partial lengths by the Antenna Selection Control Module -J515-, Traffic Monitoring Control Module -J559- or Antenna Amplifier -R24-. Only the defective sections need to be replaced.

Procedure

-- Separate the connectors of the faulty antenna wiring from their components.

-- Determine the path of the faulty antenna wire in the vehicle and measure the total length of antenna wire to be replaced.

The entire length of the antenna wire consists of the length of the required adapter leads -1- and -3- as well as the connecting wire -2-.

Fig 1: Assembly Overview Of Antenna Wire

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Subtract 60 cm from the total length of antenna wire measured, to receive the length of connecting wire -2- required.

-- Obtain the required adapter cables -1- and -3- as well as the calculated length of connecting line -2- as original replacement part .

-- Cut the connectors off of the faulty antenna wiring.

Leave the rest of the defective antenna wire in the vehicle.

-- Connect the adapter leads -1- and -3- to devices in the vehicle.

-- Route and secure connecting wire -2- in the immediate vicinity of the series-installed wire routing.

NOTE:

Antenna wires must not be kinked or excessively bent! The bending radius must not be less than 50 mm.

-- Connect the connecting wire with the adapter leads.

-- Perform a functionality test.