LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Clutch - Manual Transmission 02Q (Convertible)) >> 30 Clutch >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Component Fastener Size Nm
Clutch Pedal to Mounting Bracket Through Bolt Nut (1) - 25
Impact Bolster Support to Steering Column Bracket Bolt (1) - 20
Mounting Bracket to Bulkhead Nut (1) - 25
Pressure Plate to Dual Mass Flywheel Bolt (3)
  M6 13
M7 20
Slave Cylinder with Release Bearing to Transmission Bolt 1, 2
-- Without Locking Fluid (slave cylinder with a metal housing) - 12
-- With Locking Fluid (slave cylinder with a plastic housing) - 15
(1) Always replace
(2) Carefully tighten diagonally and in small stages so that the slave cylinder bolt tabs do not break off
(3) Loosen and tighten in small steps and in a diagonal sequence
scientia non olet · About LEMON Manuals