LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Clutch - Manual Transmission 02Q (Convertible)) >> 30 Clutch >> Removal And Installation >> Over-Center Spring >> Removing

Over-Center Spring: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and disconnect the battery ground cable. Refer to Removal and Installation .

-- Move the driver seat all the way back and raise the steering wheel to its highest position.

-- Remove the drivers side trim and the cover under the trim. Refer to "Storage Compartments, Covers and Trim" in Removal and Installation .

-- Remove the bolt -2- and the left footwell vent -1-, refer to Description and Operation .

Fig 1: Identifying Left Footwell Air Vent Remove/Install Components
GWWN80-10045Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the impact bolster support bolt -1- and impact bolster -2- before removing the clutch pedal.

Fig 2: Identifying Clutch Pedal Crash Bolster With Bolt
GWWN48-10630Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nut -arrow- and pull the ground wire from the steering column.

Fig 3: Identifying Ground Wire And Nut
GWWN48-10587Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the tabs -arrow- on both sides of the wire guide -1- toward the inside and remove the wire guide -1- from the guide on the steering column.

Fig 4: Identifying Cable Guide
GWWN48-10591Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the sound absorber -arrow- from the clutch pedal bracket, if equipped.

Fig 5: Locating Bracket With Sound Absorber
GWWN30-10195Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the retainers -A- for the sound absorber.

Fig 6: Identifying Damper Retainers
GWWN30-10188Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the sound absorber.

-- Push the sound absorber near the upper nut -1- above the clutch pedal -A- in the -direction of the arrow-.

Fig 7: Identifying Clutch Pedal Upper Nut (1)
GWWN30-10189Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nut -2- and the bolt -5- and then remove the clutch pedal -1- from the bracket -3-.

Fig 8: Identifying Clutch Pedal, Mounting Bracket, Center Spring, Nut And Bolt
GWWA30-0125Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
NOTE:

The clutch pedal remains engaged in the clutch master cylinder actuator rod.

-- Move the clutch pedal slightly downward and remove the over-center spring -4- from the bracket.