Mounting Bracket: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal. Note the following:

-- Install the mounting bracket. Refer to Tightening Specifications .

Some vehicles have a sound absorber -arrow- on the clutch pedal bracket.

Fig 1: Locating Bracket With Sound Absorber

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Move the sound absorber back into its installed position.

Replace the self-locking nuts.

NOTE:

Allocate all components correctly.

-- Install the impact bolster support -2- in front of the clutch pedal and tighten the bolt -1- to specification. Refer to Tightening Specifications .

Fig 2: Identifying Clutch Pedal Crash Bolster With Bolt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the wire guide -1- under the steering column.

Fig 3: Identifying Cable Guide

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The tabs -arrow- on both sides must clip into the wire guide.

-- Attach the ground wire to the steering column and install the nut -arrow-.

Fig 4: Identifying Ground Wire And Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the left footwell vent. Refer to "Vents" in Removal and Installation .

-- Install the drivers side trim and the cover under the trim. Refer to "Storage Compartments, Covers and Trim" in Removal and Installation .

-- Press in the hose/line assembly or pipe -1- with a new seal/O-ring -2- to the clutch master cylinder connection -4- until the clip -3- engages.

Fig 5: Identifying Hose/Line Assembly, O-Ring, Master Cylinder Connection & Securing Clip

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull on the hose/line assembly or pipe to make sure it is secure.

-- After removing the Hose Clamps up to 25 mm Diameter 3094 bring the supply hose back to its original shape.

-- Bleed the clutch system. Refer to CLUTCH SYSTEM, BLEEDING .

-- Install the battery. Refer to Removal and Installation .

-- Install the complete air filter housing, refer to one of the following:

Gas engine, refer to [For engine(s) CCTA, CBFA] Removal and Installation or [For engine(s) CPLA, CPPA] Removal and Installation .

Diesel engine, refer to [For engine(s) CVCA, CJAA] Removal and Installation or [For engine(s) CVCA] Removal and Installation .

-- Connect the battery and follow the procedure regarding what to do after connecting the battery. Refer to Removal and Installation .