Clutch Position Sensor -G476-: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal. Note the following:

NOTE:

Allocate all components correctly.

If the hose/line assembly or pipe was removed:

Fig 1: Identifying Hose/Line Assembly, O-Ring, Master Cylinder Connection & Securing Clip

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press in the hose/line assembly or pipe -1- with a new seal/O-ring -2- into the clutch master cylinder connection -4- until the clip -3- engages.

-- Pull on the hose/line assembly or pipe to make sure it is secure.

-- After removing the Hose Clamps up to 25 mm Diameter 3094, bring the supply hose back to its original shape.

-- Bleed the clutch system. Refer to CLUTCH SYSTEM, BLEEDING .

-- Install the battery tray and the battery. Refer to Removal and Installation .

-- Install the complete air filter housing, refer to one of the following:

Gas engine, refer to [For engine(s) CCTA, CBFA] Removal and Installation or [For engine(s) CPLA, CPPA] Removal and Installation .

Diesel engine, refer to [For engine(s) CVCA, CJAA] Removal and Installation or [For engine(s) CVCA] Removal and Installation .

-- Connect the battery and follow the procedure regarding what to do after connecting the battery. Refer to Removal and Installation .