Fastener Tightening Specifications

WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Component

Fastener Size

Air Conditioning Compressor to Accessory Bracket Bolt

Connecting Rod Bearing Cap to Connecting Rod Bolt ⁽¹⁾

45 + 90°

Dual Mass Flywheel to Crankshaft Bolt ⁽¹⁾

60 + 90°

Generator to Accessory Bracket Bolt

Pressure Relief Valve to Cylinder Block

Ribbed Belt Tensioner to Accessory Bracket Bolt

Sensor Wheel to Crankshaft Screw ⁽¹⁾

10 + 90°

Vibration Damper to Crankshaft Bolt ⁽¹⁾

150 + 90°

⁽¹⁾	: Always replace after removing.

Accessory Bracket Bolt Tightening Sequence and Specification

Fig 1: Accessory Assembly Bracket Bolt Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts in 3 passes in sequence -1 through 5- as follows:

-- 1st pass, tighten the bolts by hand.

-- 2nd pass, tighten the bolts to 20 Nm.

-- 3rd pass, tighten the bolts an additional 90° (1/4) turn.

Sealing Flange Bolt Tightening Sequence and Specification

Fig 2: Identifying Sealing Flange Bolt Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts in 2 passes in sequence -1 through 8- as follows:

-- 1. Tighten the bolts by hand.

-- 2. Tighten the bolts to 9 Nm.

Crankshaft Bearing Cap Bolt Tightening Sequence and Specification

Fig 3: Crankshaft Bearing Cap Bolt Tightening Sequence and Specification

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the crankshaft bearing cap bolts -1 through 10- and the -arrows- in sequence as follows:

Tighten the bolts -1 through 10- and - arrows- by hand.
Tighten the bolts -1 through 10- to 65 Nm.
Tighten the bolts -1 through 10- an additional 90° (1/4) turn using a ratchet.
Tighten the bolts -arrows- to 20 Nm.
Tighten the bolts -arrows- an additional 90° (1/4) turn using a ratchet.