Instrument Cluster -KX2-, REPLACEMENT SETTINGS
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Work procedure "replace instrument cluster" contains the following scope of work:
- If a new instrument cluster is installed in the vehicle, the Instrument Cluster Control Module -J285- must be adjusted to the various equipment characteristics and corresponding version for that country.
- To adapt the integrated Anti-Theft Immobilizer Control Module -J362- with the Engine Control Module -J623-, it is necessary to save the data from the Engine Control Module -J623- in the replacement instrument cluster.
- Also, all ignition keys must be adapted after installation of a new instrument cluster.
The procedure to "replace the instrument cluster" can only be performed using the Vehicle Diagnostic Tester in the "guided fault finding" function.
Procedure
-- Connect the Vehicle Diagnostic Tester.
-- Select Guided Fault Finding .
-- Use the GO TO button to select the "function/component selection" and the following menu options one after the other:
- Body
- Electrical System interior/exterior
- 01 - OBD
- 17 - Instrument cluster | J285
- 17 - Instrument cluster functions
- 17 - Replace instrument cluster (Repair Group 90)