Coolant Pump Driveshaft Seal: Installing

WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Clean the running and sealing surface.

-- Coat the sealing surface of the balance shaft -2- with engine oil.

Fig 1: Balance Shaft And Sealing Surface

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the seal -1- onto the balance shaft.

"Luftseite" or ("Outside") -arrow- must be readable from the outside.

-- Mount the thrust pieceT10353 on the seal -1- and press it into the cylinder block all the way with the bolt -2- ; when doing this, do not bend the seal.

Fig 2: Identifying Thrust Piece T10353, Seal And Bolt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The rest of the installation follows the reverse of the removal procedure.