After-Run Coolant Pump -V51-: Removing
WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of scalding due to hot steam and hot coolant:
- The coolant system is under pressure when the engine is warm.
- Wear protective goggles and protective clothing to prevent damage to eyes and scalding.
- Reduce pressure by covering the coolant expansion tank cap with a cloth and carefully opening.
-- Open the coolant expansion tank cap.
-- Remove the noise insulation. Refer to Removal and Installation .
-- Disconnect the after-run coolant pump connector -1-.
-- Place the drip tray for VAS 6100 VAS 6208 under the engine.
-- Clamp off the coolant hoses to the after-run coolant pump using the hose clamps up to 25 mm dia.3094
-- Reposition the hose clamps -arrows- and disconnect the coolant hoses.
-- Remove the after-run coolant pump bracket bolt -2-.