EGR Temperature Sensor -G98-: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

During installation, all cable ties must be installed at the same location.

When removing the wire do not cut it, in this case a fault diagnosis will no longer be possible.

-- Remove the engine cover, refer to ENGINE COVER .

-- If equipped remove the vacuum hose -arrow-.

Fig 1: Identifying Vacuum Hose

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the hose -1- for the crankcase ventilation on the air guide hose.

Fig 2: Identifying Release Buttons

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- To do this press the release button.

CAUTION: Depending on the vehicle equipment level and market-specific crankcase ventilation hose may be used, which cannot be removed from the cylinder head cover without being destroyed. For these version the crankcase ventilation hose can only be separated at the air guide hose connection.

-- Disconnect the connector from the crankcase housing ventilation hose -1-.

-- Unclip the wires on the intake tube.

-- Free up the vacuum hoses -arrows- on the air guide pipe.

-- Remove bolt -2- and tilt the air guide pipe with the intake tube backward and remove from the turbocharger.

-- Disconnect the connector -2- and free up the wire.

Fig 3: Identifying EGR Temperature Sensor

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the EGR Temperature Sensor -G98- -1-.