Overview - Exhaust Temperature Regulation, Vehicles With SCR System
WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
There is a risk of malfunctions from loose exhaust gas temperature sensor.
- The exhaust gas temperature sensor threads -G495- and -G648- are coated. Do NOT coat with hot bolt paste and make sure to tighten to the tightening specification.
- Exhaust Gas Temperature Sensor 4 -G648-
- 60 Nm
- Removing and installing, refer to EXHAUST GAS TEMPERATURE SENSOR 3 -G495- /EXHAUST GAS TEMPERATURE SENSOR 4 -G648- .
- The exhaust gas temperature sensor thread is coated and cannot be coated with hot bolt paste.
- Exhaust Gas Temperature Sensor 1 -G235-
- 45 Nm
- Removing and installing, refer to EXHAUST GAS TEMPERATURE SENSOR 1 -G235- .
- Coat the with hot bolt paste.
- EGR Temperature Sensor -G98-
- 60 Nm
- NOx Sensor -G295-
- Removing and installing, refer to NOx SENSOR -G295- .
- Heated Oxygen Sensor -G39- with Oxygen Sensor Heater -Z19-
- Removing and installing, refer to OXYGEN SENSOR 1 BEFORE CATALYTIC CONVERTER -GX10- .
- Bracket
- For the Differential Pressure Sensor
- Differential Pressure Sensor -G505-
- Removing and installing, refer to DIFFERENTIAL PRESSURE SENSOR -G505- .
- Bolt
- 8 Nm
- Exhaust Pressure Sensor 1 -G450-
- Removing and installing, refer to EXHAUST PRESSURE SENSOR 1 -G450- .
- Bolt
- 8 Nm
- Exhaust Gas Temperature Sensor 3 -G495-
- 45 Nm
- Removing and installing, refer to EXHAUST GAS TEMPERATURE SENSOR 3 -G495- /EXHAUST GAS TEMPERATURE SENSOR 4 -G648- .
- The exhaust gas temperature sensor thread is coated and cannot be coated with hot bolt paste.
- Exhaust Gas Temperature Sensor 2 -G448-
- 60 Nm
- The exhaust gas temperature sensor thread is coated and cannot be coated with hot bolt paste.
- Removing and installing, refer to EXHAUST GAS TEMPERATURE SENSOR 2 -G448- .