Engine And Transmission, Separating: Procedure

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Bracket

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Engine/transmission assembly removed and mounted on Engine/Gearbox Jack - Engine Support T10359.

-- Free up the electrical wires on the bracket -arrow-.

-- Remove the bolts -1 and 2- and then remove the starter from the transmission.

Fig 2: Identifying Starter

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure the transmission on the Shop Crane VAS6100 using the Engine/Gearbox Support Shackle (2 pc.) 10-222A/12.

Fig 3: Identifying Shop Crane VAS6100 And Engine/Gearbox Support Shackle

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -1, 3, 4, 5, 6, 7 and 8- that connect the transmission to the engine.

Fig 4: Locating Alignment Sleeves

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the transmission from the engine.