LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Clutch - Manual Transmission 0A4 (Convertible)) >> 30 Clutch >> Removal And Installation >> Over-Center Spring >> Removing

Over-Center Spring: Removing

WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the battery ground cable, refer to REMOVAL AND INSTALLATION .

-- Move the driver seat all the way back and raise the steering wheel to it highest position.

-- Remove the drivers side trim and the cover under the trim, refer to "Storage Compartments, Covers and Trim" in REMOVAL AND INSTALLATION .

-- Remove the bolt -2- and the left footwell vent -1-, refer to DESCRIPTION AND OPERATION .

Fig 1: Identifying Left Footwell Air Vent Remove/Install Components
GWWN80-10045Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Remove the impact bolster support bolt -1- and impact bolster support -2-.

Fig 2: Identifying Clutch Pedal Crash Bolster With Bolt
GWWN48-10630Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nut -arrow- and the ground wire from the steering column.

Fig 3: Identifying Ground Wire And Nut
GWWN48-10587Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the tabs -arrow- on both sides of the wire guide -1- toward the inside and remove the guide -1- from the steering column.

Fig 4: Identifying Cable Guide
GWWN48-10591Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the sound absorber -arrow- from the clutch pedal bracket, if equipped.

Fig 5: Bracket With Sound Absorber
GWWN30-10195Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the retainers -A- for the sound absorber.

Fig 6: Identifying Damper Retainers
GWWN30-10188Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the sound absorber.

-- Push the sound absorber near the upper nut -1- above the clutch pedal -A- in the -direction of the arrow-.

Fig 7: Clutch Pedal Upper Nut
GWWN30-10189Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nut -2- and the bolt -5- and then remove the clutch pedal -1- from the bracket -3-.

Fig 8: Identifying Clutch Pedal, Mounting Bracket, Center Spring, Nut And Bolt
GWWA30-0125Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
NOTE: The clutch pedal remains engaged in the clutch master cylinder actuator rod.

-- Swivel the clutch pedal slightly downward and remove the over-center spring -4- from the bracket.