Mounting Bracket: Installing

Install in reverse order of removal. Note the following:

Some vehicles have a sound absorber -arrow- on the clutch pedal bracket.

Fig 1: Bracket With Sound Absorber

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Move the sound absorber back into its installed position.

Replace the self-locking nuts.

-- Install the impact bolster support -2- and tighten the bolt -1- to specification, refer to Tightening Specifications .

Fig 2: Identifying Clutch Pedal Crash Bolster With Bolt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the wire guide -1- under the steering column.

Fig 3: Identifying Cable Guide

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The tabs -arrow- on both sides must clip into the column.

-- Install the ground wire to the steering column and install the nut -arrow-.

Fig 4: Identifying Ground Wire And Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the left footwell vent, refer to "Vents" in REMOVAL AND INSTALLATION .

-- Install the drivers side trim and the cover under the trim, refer to "Storage Compartments, Covers and Trim" in REMOVAL AND INSTALLATION .

-- Press the hose/line assembly or pipe -1- with a new seal or O-ring -2- into the clutch master cylinder connection -4- until the clip -3- fully engages.

Fig 5: Identifying Hose/Line Assembly, O-Ring, Master Cylinder Connection & Securing Clip

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull on the hose/line assembly to make sure it is secure.

-- After removing the Hose Clamps up to 25 mm Diameter 3094, bring the supply hose back to its original shape.

-- Bleed the clutch system, refer to CLUTCH SYSTEM, BLEEDING .

-- Install the battery and battery tray, refer to REMOVAL AND INSTALLATION .

-- Install the air filter housing, refer to [For engine(s) CCTA, CBFA] Removal and Installation[For engine(s) CBUA] Removal and Installation[For engine(s) CPRA, CPKA, CPLA, CPPA] Removal and Installation .

-- Connect the battery and follow the procedure regarding what to do after connecting the battery, refer to REMOVAL AND INSTALLATION .