Clutch Position Sensor -G476-: Installing

WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE: Allocate all components.

If the hose/line assembly or pipe line was removed:

Fig 1: Identifying Hose/Line Assembly, O-Ring, Master Cylinder Connection & Securing Clip

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the hose/line assembly or pipe -1- with a new seal or O-ring -2- into the clutch master cylinder connection -4- until the clip -3- engages.

-- Pull on the hose/line assembly or pipe to make sure it is secure.

-- After removing the Hose Clamps up to 25 mm Diameter 3094 bring the return hose back to its original shape.

-- Bleed the clutch system, refer to CLUTCH SYSTEM, BLEEDING .

-- Install the battery tray and the battery, refer to REMOVAL AND INSTALLATION .

-- Install the air filter housing, refer to [For engine(s) CCTA, CBFA] Removal and Installation [For engine(s) CBUA] Removal and Installation [For engine(s) CPRA, CPKA, CPLA, CPPA] Removal and Installation

-- Connect the battery and follow the procedure regarding what to do after connecting the battery, refer to REMOVAL AND INSTALLATION .