Clutch Overview, With Single Flywheel

WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Flywheel, Clutch Plate, Pressure Plate & Bolt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Flywheel
- Removing and installing, refer to [For engine(s) CPRA, CPKA, CPLA, CPPA] Removal and Installation [For engine(s) CVCA] Removal and Installation [For engine(s) CCTA, CBFA] Removal and Installation [For engine(s) CBUA] Removal and Installation .
- Make sure it fits securely on the centering pins.
- Keep the clutch lining contact surface free of grooves, oil and grease.
Clutch Plate
- The spring cage faces the pressure plate.
- Centering CLUTCH, WITH SINGLE FLYWHEEL .
- Lightly grease the splines
- Allocation.
Pressure Plate
- Removing and installing CLUTCH, WITH SINGLE FLYWHEEL .
- Check the ends of the diaphragm spring Figure
- Checking the spring connections and rivet connections Figure
Bolt
- Tightening specification for M6: 13 Nm
- Tightening specification for M7: 20 Nm
- Loosen and tighten diagonally and in steps.
- Allocation.