Triple Roller Joint AAR3300I: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Remove any paint residue and/or corrosion on the outer joint threads/splines.

-- Insert drive axle.

-- Install the outer joint as far as possible into the wheel hub splines.

-- Attach the ball joint to the control arm -arrows-.

Fig 1: Identifying Nuts, Tightening

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Make sure the ball joint boot is not damaged or twisted.

-- Install inner joint of drive axle and initially tighten bolts diagonally to 10 Nm.

-- Tighten the internal multi-point bolts diagonally to the tightening specification.

-- Install the lower noise insulation. Refer to NOISE INSULATION OVERVIEW .

-- Tighten drive axle bolt onto the wheel hub. Refer to THREADED CONNECTION, LOOSENING AND TIGHTENING .

NOTE:

Vehicle must not be standing on its wheels when doing this, otherwise wheel bearing will be damaged.

-- Install the wheel and tighten the wheel bolts. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .