Triple Roller Joint AAR2600I: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the drive axle bolt. Refer to THREADED CONNECTION, LOOSENING AND TIGHTENING .

CAUTION:

The wheel bearing must not be under a load while the drive axle threaded connection on the wheel side is loose.

If the wheel bearings are under the load of the vehicle weight, the wheel bearing will be damaged. This reduces the service life of the wheel bearings.

The drive axle bolt may be loosened maximum 90° when the vehicle is standing on its wheels.

Vehicles without a drive axle must not be moved, otherwise the wheel bearing will be damaged. If a vehicle must be moved, be sure to note the following:

Install an outer joint in place of the drive axle.
Tighten the outer joint to 120 Nm.

-- Loosen the wheel bolts.

-- Raise the vehicle.

-- Remove the wheel.

-- Remove the lower noise insulation. Refer to NOISE INSULATION OVERVIEW .

-- Remove the nuts -arrows-.

Fig 1: Identifying Nuts -Arrows- On Left And Right Side Of Vehicle, Removal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove both the wheel bearing housing and ball joint from the control arm.

-- Pull drive axle out from wheel hub and secure it to body.

If the Drive Axle Cannot be Pulled Out of the Wheel Bearing, then it can be Pushed Out of the Wheel Bearing Using the RemoverT10520.

Before using the RemoverT10520 pay attention that the thrust piece -1- is installed.

Fig 2: Locating Thrust Piece

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Using the RemoverT10520:

Fig 3: Identifying Remover T10520

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure the RemoverT10520 -1- with three wheel bolts -2- on the wheel hub, so that the drive axle -3- can be pressed out.

-- Follow the specified sequence.

Fig 4: Identifying Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

I -

Tighten the knurled nut -1- hand-tight.

II -

Turn only the bolt -2- with a wrench and press out the drive axle with the RemoverT10520.

NOTE:

At the end of the tasks or to set back, the spindles must be brought back into the original position so that the hydraulic operation can be used.

-- Place the Drive Axle Wedge ToolT10161 -1- between the transmission housing and the triple roller joint.

Fig 5: Identifying Drive Axle Wedge Tool

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Using a rubber hammer, hit the inner joint on the Drive Axle Wedge ToolT10161 and remove it from the transmission.

-- Remove drive shaft.