Tie Rod End: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Make sure the correct tie rod end is installed on each side.

Fig 1: Identifying Tie Rod Ends

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

I -

Right tie rod end identified with an "A"

II -

Left tie rod end identified with a "B"

-- Turn the tie rod end to marking made earlier on the tie rod and secure it with a locking nut.

-- Install the tie rod end into the wheel bearing housing.

-- Install the tie rod end with a new nut.

-- Install the front wheel and tighten the bolts. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Perform vehicle alignment. Refer to VEHICLE ALIGNMENT .