Steering Column: Removing
The Electronic Steering Column Lock Control Module -J764- is attached to the steering column by shear head screws and can only be replaced together with the complete steering column.
All information. Refer to Vehicle Diagnostic Tester.
The steering column is delivered only as a complete replacement part. Servicing is not possible.
The steering lock housing can be removed and installed. Refer to [For transmission(s) 0A4, 02E, 09G, 02Q] [For engine(s) CVCA, CPRA, CPKA, CPLA, CJAA, CBUA, CPPA, CCTA, CBFA] Description and Operation .
- The technician must electrostatic discharge. This is done by touching a grounded metal part, for example, water lines, heater pipe, metal carriers or a workshop hoist. Refer to ELECTRICAL COMPONENTS .
If this not done, the Electronic Steering Column Lock Control Module -J764- could fail later.
- Disconnect the battery ground cable. Refer to [For transmission(s) 0A4, 02E, 09G, 02Q] [For engine(s) CVCA, CPRA, CPKA, CPLA, CJAA, CBUA, CPPA, CCTA, CBFA] Removal and Installation .
- The wheels must be in the straight-ahead position.
The airbag system may not work properly if you do not follow these WARNINGS.
-- Set the wheels to the straight ahead position.
-- Pull the lever on the side of the steering column downward.
-- Push the steering column as far down as possible and remove it.
-- Push lever under steering column upward again.
-- Remove the airbag unit. Refer to Removal and Installation .
-- Remove steering wheel. Refer to STEERING WHEEL .
-- Remove the steering column upper trim. Refer to "Storage Compartments and Covers" in Removal and Installation .
-- Remove the steering column lower trim. Refer to "Storage Compartments and Covers" in Removal and Installation .
-- Remove the steering column switch module. Refer to [For transmission(s) 0A4, 02E, 09G, 02Q] [For engine(s) CVCA, CPRA, CPKA, CPLA, CJAA, CBUA, CPPA, CCTA, CBFA] Description and Operation .
Vehicles with Ignition Switch
-- Disconnect the harness connector -1-.
Vehicle with "Keyless Access" Keyless Locking and Starting System
-- Disconnect the harness connector -1-.
-- Unclip the wire from the retainer on the Electronic Steering Column Lock Control Module -J764- -arrow-.
Continuation for All Vehicles
-- Remove the nut -arrow- and pull the ground off from the steering column.
-- Push the tabs -arrow- on both sides of the cable guide -1- toward the inside.
-- Pull the cable guide -1- out of the guide on the steering column.
-- Remove the bolts -1- and cover -2-.
-- Remove the screw -arrow- from the universal joint -1-. Then remove the universal joint in direction of -arrow-.
With Manual Transmission
-- Remove the left bolt -1- and the clutch pedal crash bolster -2-.
Vehicles with a DSG Transmission and Automatic Transmission
-- Remove the left steering column bolt -1-.
Continuation for All Vehicles
-- Remove the right bolt -1- and the brake pedal crash bolster -2-.
-- Remove the bolt on the left side -1- while holding the steering column secure.
-- Lower the steering column -1- slightly.
-- Pull the steering column -1- carefully forward out of the guide on the bracket -arrow-.