Assembly Mounts Overview

WARNING: This page is about a different car, the 2014 Volkswagen Beetle and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Engine Mount Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

= 40 Nm + 90°, when replacing the bolts
= 20 Nm + 90°, when replacing the bolts
= 60 Nm + 90°, when replacing the bolts

Fig 2: Identifying Transmission Mount & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A -

= 40 Nm + 90°, when replacing the bolts

B -

= 60 Nm + 90°, when replacing the bolts

Fig 3: Identifying Pendulum Supports & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE: Attach the pendulum support to the transmission first and then to the subframe.

A -

Strength category 10.9 = 50 Nm + 90°, when replacing the bolts

B -

= 100 Nm + 90°, when replacing the bolts

Removing: remove the bolt -B- first and then the bolts -A-.

Installing: first tighten the bolt -A- and then bolt -B-.