Rear Bumper Cover: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the connectors from any electrical components.

-- Slide the rear bumper cover -1- parallel onto the guides on the vehicle until the rear bumper cover -1- on the left and right guide -7- engages near the tail lamps -arrows b-.

-- Install the rear bumper cover -1- onto the left and right guides until it locks.

-- Pay attention to the parallel alignment and the gap dimensions.

-- Install the bolt -6- under the left and right tail lamps and tighten them.

-- Install the left and right tail lamps, refer to[For transmission(s) 0A4, 02E, 09G, 02Q] [For engine(s) CVCA, CPRA, CPKA, CPLA, CJAA, CBUA, CPPA, CCTA, CBFA] Removal and Installation .

-- Tighten the bolts -5- inside the wheel housing on the left and right.

NOTE: On some vehicles can an expanding rivet also be installed.

-- Install the left and right bolts -2- from below as well as the bolt -4- in the wheel housing and tighten them.

-- Install the expanding rivets -3- from below.