Name Badges
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Hot Air Blower VAG1416
- Adhesive Strip Remover VAS6349
Assembly Information
- It is not possible to remove a name plate or brand emblem without damaging it.
- Heat the name plates or brand emblem before removing using the Hot Air Blower VAG1416.
- If present, remove any remaining adhesive with the Adhesive Strip Remover VAS6349 and the adhesive remover
- If installing a name badge or brand emblem for the first time on newly painted surfaces, follow the procedure described in Paint Repair Service Information.
- Make sure there is no dust or grease on the adhesive surfaces.
- Install the name plate or brand emblem immediately after cleaning.
- Peel off the backing on the name badge or brand emblem just before installing it.
- The temperature must be approximately 21 °C (70 °F).