LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (2.0L - Exhaust System, Emission Controls - Engine Code(S): CBFA & CCTA (Convertible)) >> 26 Exhaust System, Emission Controls >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Component Fastener Size Nm
Clamping Sleeve Nut
-- Individual Clamp - 25
-- Continuous Clamp - 35
Cross Member to Underbody Nut - 20
Front Exhaust Pipe with Catalytic Converter to Exhaust Manifold/Turbocharger Nut 1, 3 - 40
Oxygen Sensor - 55
Secondary Air Injection Pump Motor Bracket to Underbody Nut (2) - 25
Secondary Air Injection Pump Motor to Bracket Nut (2) - 9
Secondary Air Injection Solenoid Valve Bolt (2) - 9
Suspended Mount to Subframe Bolt - 25
Suspended Mount to Underbody Bolt - 25
(1) : Always replace after removing.
(2) : Engine code CBFA only.
(3) : Lubricate the stud bolts on the exhaust manifold/turbocharger with hot bolt paste G 052 112 A3.
scientia non olet · About LEMON Manuals