Secondary Air Injection Pump Motor -V101-: Removing

WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Engine Code CBFA

Special tools and workshop equipment required

Torque Wrench (5-50 Nm) V.A.G 1331

-- Remove the noise insulation. Refer to Removal and Installation .

-- Remove the left front wheel.

-- Remove the left front wheel housing liner. Refer to Removal and Installation .

-- Disconnect the connecting pipes -1-, remove the nuts -2-, disconnect the electrical connector -3- and remove the Secondary Air Injection (AIR) pump motor.

Fig 1: Identifying Secondary Air Injection Pump Motor And Mounting Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE: Press the securing ring to disengage the connecting pipes.