Clamping Sleeve Locations

WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Gradual introduction of clamping sleeves with a continuous clamp.

Fig 1: Identifying Tightening Torque And Installed Dimension Of Clamping Sleeve

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Clamping sleeve -A- with 2 individual clamps.

Tightening specification: 25 Nm

Installed dimension -a- 5 mm (only for front clamping sleeve)

Clamping sleeve -B- with a continuous clamp.

Tightening specification: 35 Nm

Installed dimension -a- 8.5 mm (only for front clamping sleeve)

Fig 2: Aligning Front Clamping Sleeve

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1 -

Clamping sleeve

2 -

Front exhaust pipe

a -

Installed dimension

A -

Mark

Fig 3: Identifying Installed Position Double Clamps In Direction Of Travel

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the clamping sleeve so that the bolt end -arrow- does not project beyond the lower edge of the clamping sleeve.

Threaded connection points toward the right.

Fig 4: Identifying Installed Position Double Clamps In Direction Of Travel

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the clamping sleeve so that the bolt end -arrow- does not project beyond the lower edge of the clamping sleeve.

Threaded connection points to the rear