LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (1.8L & 2.0L - Exhaust System, Emission Controls - Engine Code(S): CPKA, CPLA, CPPA & CPRA (Convertible)) >> 26 Exhaust System, Emission Controls >> General Information >> Clamping Sleeve Locations >> Installed Position For Rear Clamping Sleeve >> Tightening Specifications

Tightening Specifications

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, and 2014 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Tightening Torque And Installed Dimension Of Clamping Sleeve
GWWN26-10627Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Clamping sleeve -A- with two individual clamps.

Tightening specification: 25 Nm.

Clamping sleeve -B- with continuous clamp.

Tightening specification 35 Nm.