Installed Position For Front Clamping Sleeve

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, and 2014 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Aligning Front Clamping Sleeve

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Installed dimension -a- is approximately 1 cm

A -

End of bead

1 -

Clamping sleeve

2 -

Front exhaust pipe

a -

Installed dimension

Fig 2: Identifying Tightening Torque And Installed Dimension Of Clamping Sleeve

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Clamping sleeve -A- with two individual clamps.

Tightening specification: 25 Nm.

Installation dimension -a- 5 mm (only for front clamping sleeve)

Clamping sleeve -B- with continuous clamp.

Tightening specification 35 Nm.

Fig 3: Identifying Installed Position Double Clamps In Direction Of Travel

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

-- Install the clamping sleeve so that the bolt end -arrow- does not project beyond the lower edge of clamping sleeve.

Threaded connection points toward the right.