LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Exterior Body Panels (Hood, Lids) (Convertible)) >> (55 Hood, Lids) >> Description And Operation >> Rear Lid, Adjusting, Sedan >> Side Adjusting Buffer, Adjusting

Side Adjusting Buffer, Adjusting

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Unclip the cap -1- from the adjusting buffer -3-.

Fig 1: Adjusting Side Adjusting Buffer
GWWM55-10101Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Slightly loosen the bolt -2- on the adjusting buffer -3- until the adjusting buffer moves easily.

-- Slide the adjusting buffer -3- in the direction of -arrow- until it stops.

-- Carefully press the middle of the rear lid at the lower end of the rear window -arrow- shut until in the initial locking position.

Fig 2: Closing Rear Lid
GWWM55-10119Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Open the rear lid again.

-- Tighten the bolt -2-.

Fig 3: Identifying Bolt
GWWM55-10101Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip the cap -1- from the adjusting buffer -3-.

Adjustment, Checking

-- Lay a sheet of paper between the contact surface for the rear lid and the side adjusting buffers.

Fig 4: Checking Rear Lid Adjustment
GWWM55-10120Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Close the rear lid and pull on the paper -arrow-.

-- Check the adjustment of the 3 other adjusting buffers in the same way.

Fig 5: Checking Rear Lid Adjustment
GWWM55-10121Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If the sheet of paper can be pulled out from an adjusting buffer, adjust that buffer again.