Rear Seat Backrest, Convertible: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Position the backrest in the vehicle.

Fig 1: Identifying Backrest

CAUTION:

Do not fold the backrest as long as the bench seat is not installed!

-- Install the bolt -1- by hand with the dual seat belt latch -2- but do not tighten it yet.

Fig 2: Identifying Bolt And Dual Seat Belt Latch

-- Tighten the bolts on both sides of the backrest -1- and -2- to the tightening specification.

Fig 3: Identifying Bolts

-- Tighten the bolts -1- and -2- int the upper section of the spare wheel well to the tightening specification.

Fig 4: Identifying Bolts

-- Tighten the bolt -1- to the tightening specification.

Fig 5: Identifying Bolt And Dual Seat Belt Latch

-- If equipped, connect the connector -1- and secure it in the mount -2- .

Fig 6: Identifying Connector And Retainer

-- Install the right and left luggage compartment trim panels. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, CONVERTIBLE .

-- Install in reverse order of removal.