Rear Seat Backrest Locking Mechanism, Sedan: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the bench seat. Refer to SEAT BENCH/SINGLE SEAT .

CAUTION:

Do not press the rear seat backrests onto the center backrest mounting! To prevent damage to the backrest cover, place a foam piece or similar material between the backrest mounting and the backrest!

-- Remove the luggage compartment carpet. Refer to LUGGAGE COMPARTMENT FLOOR PANEL .

-- Remove the rear dual seat belt latch. Refer to REAR BELT LATCH .

-- Remove the C-pillar trim. Refer to C-PILLAR TRIM .

-- Remove side trim. Refer to SIDE TRIM PANEL, SEDAN .

-- Fold the side luggage compartment trim panel toward the rear.

-- Remove the rear seat backrest. Refer to REAR SEAT BACKREST, SEDAN .

-- Remove the attachment and the backrest upholstery. Refer to REAR SEAT BACKREST COVER AND CUSHION, SEDAN

-- Remove the adhesive foil near the cable on the backside of the backrest.

Fig 1: Identifying Bolts

-- Remove the bolts -1- on the backside of the backrest (3 Nm).

-- Remove the bolt -2- on the front side of the backrest (3 Nm).

-- Remove the lock and the release cable -3- from the backrest shell.

NOTE:

Release cable is not designed to be disconnected from the release.

-- Unclip the release cable -6- from the mount -5- .

-- Unhook the release cable hooks -4- .