Seat Height Adjustment Handle: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Seat Height Adjustment And Lever

NOTE:

Remove the seat height adjustment -1- as instructed. Never remove the seat height adjustment from the lever -2- .

If the tab -arrow- gets damaged while removing the seat height adjustment handle, then it is not possible to install the handle again. The handle must be replaced.

-- Pull seat height adjustment handle -1- up as far as the stop and hold it in that position.

Fig 2: Identifying Seat Height Adjustment Handle

-- Carefully pull the seat height adjustment slightly off the front seat.

-- Guide a small screwdriver between the seat height adjustment and the trim -2- .

-- Unlock the release -3- using the screwdriver and at the same time, pull the seat height adjustment handle in the direction of the -arrow- from the lever.