Gliding Piece: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Slider And Seat Rail

-- Install the slider into the seat rail -1- by slightly tipping it toward the tunnel.

-- Engage the slider in the back catch -arrow- .

-- Tighten the rear bolt on the seat on the tunnel side (40 Nm).

-- Tilt the backrest back while sliding the seat all the way back (entry assistance).

-- Release the seat forward/back adjuster and slide the front seat into the desired position.

NOTE:

It is not necessary to adjust the slider.