Glow Plug Connectors, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Before removing the glow plug connectors, note that different installation depths for the glow plugs in their respective cylinders.

-- Position the Pliers3314 with the groove -arrow A- on the upper collar of the connector -arrow B- and press together lightly.

Fig 1: Identifying Pliers 3314 Positioned With Groove

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

Mount the pliers so that it cannot touch or damage the cable.

Use only the tool shown.

Other unsuitable tools can damage the connector.

If the connector is damaged when removing it, replace the complete wiring harness including the connector (a connector cannot be replaced separately).

-- Pull the connector carefully off the glow plug using Pliers3314.

Fig 2: Carefully Pulling Connector Off Glow Plug

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

Do not pull abruptly on the connector.

Do not damage the connector wire.

Do not press the pliers together too firmly or the connector will be damaged.

The connector is surround by a protective sleeve. Replace the protective sleeve if it is damaged.