LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (2.0L - Cylinder Head & VALVETRAIN - Engine Code: CVCA (Convertible)) >> 15 Cylinder Head, VALVETRAIN >> Diagnosis And Testing >> Compression Pressure, Checking >> Procedure

Compression Pressure, Checking: Procedure

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Connector On Fuel Pressure Regulator Valve
GWWA23-10698Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the engine cover, refer to ENGINE COVER .

-- Disconnect the connector on the Fuel Pressure Regulator Valve - N276- -2-.

-- In order to reduce the fuel pressure in the high pressure reservoir, start the engine briefly.

-- Remove all glow plugs, refer to GLOW PLUG .

-- Install the Compression Tester Kit - Adapter 8 VAG 1763/8 in place of the glow plug and connect the Compression Tester Kit VAG 1763.

Fig 2: Identifying Compression Tester Kit
GWWA15-11422Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
NOTE: For information on using the tester, refer to the Operating Instructions.

-- Have a second technician operate the starter until the test stops showing an increase in pressure.

-- Repeat procedure on each cylinder.

Compression Pressure Pressure
New 25.0 to 31.0 (362.5 to 449.6 psi)
Wear limit 19.0 (275.5 psi)
Maximum difference between cylinders 5.0 (72.5 psi)