Satellite Antenna -R170-, CONVERTIBLE, IN INSTRUMENT PANEL: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Switch off the ignition and all electrical consumers and remove the ignition key.

Vehicles without Auxiliary Instruments:

-- Remove the instrument panel center cover. Refer to Removal and Installation .

-- Remove the bolts -arrows- from the Satellite Antenna -R170- -1- and then pull the Satellite Antenna -R170- -1- upward and out.

Fig 1: Identifying Satellite Antenna With Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disengage the connector and disconnect.

Vehicles with Auxiliary Instruments:

The Satellite Antenna -R170- is bolted to a mounting plate. The mounting plate is bolted to the auxiliary instruments trim.

-- Remove the auxiliary Instruments trim. Refer to [For transmission(s) 0A4, 02E, 09G, 02Q] [For engine(s) CVCA, CPRA, CPKA, CPLA, CJAA, CBUA, CPPA, CCTA, CBFA] Removal and Installation .

-- Remove the bolts -arrows- from the mounting plate -1- and remove the mounting plate from the trim.

Fig 2: Identifying Mounting Plate And Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows- from the Satellite Antenna -R170- -1- and then pull the Satellite Antenna -R170- -1- upward and out.

Fig 3: Identifying Bolts And Satellite Antenna

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.