LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (2.0L - Engine Lubrication - Engine Code(S): CJAA & CVCA (Convertible)) >> 17 Engine Lubrication >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Component Fastener Size Nm
Chain Tensioner with Tensioning Rail to Cylinder Block Bolt - 15
Oil Filter Cap - 25
Oil Filter Housing to Cylinder Block Bolt 1, 2 - 15 + 90°
Oil Filter Housing Lower Cover - 25
Oil Level Thermal Sensor to Oil Pan Bolt - 10
Oil Pan Drain Plug1 - 30
Oil Pan to Transmission Bolt - 40
Oil Pressure Switch - 22
Oil Pump Sprocket to Oil Pump Bolt1 - 20 + 90°
Oil Pump to Cylinder Block - 15
Oil Spray Jet to Cylinder Block Bolt - 27
Oil Supply Line to Connection - 22
Oil Supply Line Connection to Oil Filter Housing - 30
Sealing Flange to Cylinder Block Bolt - 15
Splash Wall to Cylinder Block Bolt - 15
Suction Line to Oil Pump Bolt - 15
Wiring Harness Bracket to Oil Filter Housing Bolt - 10
  • 1 Always replace
  • 2 First, fasten upper left and lower right bolts, and then tighten all four bolts in a diagonal sequence
Fig 1: Identifying Oil Pan Bolt Loosening Sequence
GWWA17-0219Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
NOTE:

Replace the oil pan screws.

-- Tighten the bolts in three steps:

Stage Bolts Tightening specification
1. -1- through -20- In a diagonal sequence, to 5 Nm
2. -Arrows- 40 Nm
3. -1- through -20- Diagonally in steps at least to 15 Nm
scientia non olet · About LEMON Manuals