Transmission Housing, Servicing

WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Needle Bearing Drift VW295
Adapter VW295 A
Thrust Pad VW447 H
Thrust Pad VW512

Fig 1: Driving Out Needle Bearing

Fig 2: Driving In Needle Bearing To Stop

-- Secure the needle bearing at three points inside the transmission housing, offset by 120°, using a mandrel.

Fig 3: Identifying Oil Collector Tray Installed Into Transmission Housing

-- Insert the oil catch tray -A- into the hole -arrow 1- and groove -arrow 2- at the same time.