Clutch Housing, Servicing

WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Slide Hammer-Complete Set VW771
Additional Part for VW771VW771/37
Spindle from the Seal Installer Driver Set 3066
Thrust Piece T10148

Fig 1: Identifying VW 771/37 Tool To Pull Out Sleeve And Seal

The sleeve has a shoulder on the inside.

-- Mount the additional part for VW771VW771/37 behind the shoulder inside the sleeve.

-- Using force, push the additional part for VW771VW771/37 into the sleeve.

Fig 2: Identifying Spindle And Nut To Pull Sleeve And Seal

-- Clean the seat for the shaft seal inside the transmission.

-- Attach the spindle -A- on the seal installer set - rear diff 3066 into the threaded piece on the differential.

-- Turn the nut -B- and pull the seal with sleeve all the way over the thrust piece T10148.

NOTE:

If the transmission is disassembled, press the seal and sleeve in until seated using the thrust padT10148.