LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (2.0L - Diesel Fuel Injection - Engine Code: CVCA (Convertible)) >> 23 Diesel Fuel Injection >> Removal And Installation >> Exhaust Pressure Sensor 1 -G450- >> Installing

Exhaust Pressure Sensor 1 -G450-: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Before installing the control lines leading from Exhaust Pressure Sensor 1 -G450- to the particulate filter, clean them with compressed air to make sure they are not plugged or iced over by condensation water.

Check the hose for secure fit and leaks.

Secure all hose connections with hose clamps .

-- Install the engine cover, refer to ENGINE COVER .

-- After replacing the Exhaust Pressure Sensor 1 Exhaust Pressure Sensor 1 -G450- reset the adaption values, refer to Vehicle Diagnostic Tester, GUIDED FUNCTIONS  , 01 - RESET THE ADAPTATION VALUES  .

scientia non olet · About LEMON Manuals