Overview - Heated Oxygen Sensor, Vehicles Without SCR System
WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Oxygen Sensor after Three Way Catalytic Converter -G130- with Heater for Oxygen Sensor 1 after Catalytic Converter -Z29-
- 52 Nm
- Removing and installing, refer to OXYGEN SENSOR AFTER THREE WAY CATALYTIC CONVERTER -G130- .
- Follow the installation instructions, refer to OXYGEN SENSOR AFTER THREE WAY CATALYTIC CONVERTER -G130-
- Exhaust Gas Temperature Sensor 4 -G648-
- If equipped depends on the depending on the exhaust gas standard
- Removing and installing, refer to EXHAUST GAS TEMPERATURE SENSOR 3 -G495- /EXHAUST GAS TEMPERATURE SENSOR 4 -G648- .
- Exhaust Gas Temperature Sensor 1 -G235-
- Removing and installing, refer to EXHAUST GAS TEMPERATURE SENSOR 1 -G235- .
- Exhaust Gas Temperature Sensor 2 -G448-
- Removing and installing, refer to EXHAUST GAS TEMPERATURE SENSOR 2 -G448- .
- Bolt
- 8 Nm
- Differential Pressure Sensor -G505-
- If equipped depends on the depending on the exhaust gas standard
- Removing and installing, refer to DIFFERENTIAL PRESSURE SENSOR -G505- .
- Bracket
- For the Differential Pressure Sensor
- Exhaust Pressure Sensor 1 -G450-
- Removing and installing, refer to EXHAUST PRESSURE SENSOR 1 -G450- .
- Bolt
- 8 Nm
- Exhaust Gas Temperature Sensor 3 -G495-
- if equipped depends on the depending on the exhaust gas standard
- Removing and installing, refer to EXHAUST GAS TEMPERATURE SENSOR 3 -G495- /EXHAUST GAS TEMPERATURE SENSOR 4 -G648- .
- Heated Oxygen Sensor -G39- with Oxygen Sensor Heater -Z19-
- 52 Nm
- if equipped depends on the depending on the exhaust gas standard
- Removing and installing, refer to OXYGEN SENSOR 1 BEFORE CATALYTIC CONVERTER -GX10- .
- Emissions Control Module