Fuel Pressure Sensor -G247-: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER .

-- Before removing, clean the threaded area around the fuel pressure sensor -G247- (for example using commercially available coolant). Contamination must not enter the bore in the rail element (high pressure reservoir).

NOTE: Clean carefully, cleaner must not enter the connector.

-- Dry the Fuel Pressure Sensor --.

-- Disconnect the connector on the Fuel Pressure Sensor -G247- -C-.

Fig 1: Disconnecting Fuel Injector Connectors

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the Fuel Pressure Sensor -G247-.

-- Extract the contamination from the rail element bore (threads and sealing surface). Do not use mechanical tools.

NOTE: Seal the rail element bore immediately with a suitable plug to prevent contaminants from entering.