Fuel Pressure Sensor -G247-: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Check the Fuel Pressure Sensor -- sealing surface and threads for damage.

Check the sealing surface on the rail element bore.

The Fuel Pressure Sensor -- threads are coated with an anti-friction coating so they must be free of oil and grease.

-- First tighten the Fuel Pressure Sensor -G247- by hand.

-- Tighten the Fuel Pressure Sensor -- :

Tightening specification -item 14.

-- After installing, let the engine run at a moderate speed for a few minutes and then stop it.

-- Check the fuel system for leaks. Refer to FUEL SYSTEM, PERFORMING LEAK TEST .

-- The DTC memory for the Engine Control Module -- again using the Vehicle Diagnostic Tester in "Guided Functions".

-- Install the engine cover. Refer to ENGINE COVER .