Brake Lamp Switch -F-, WITH 4-CYLINDER GASOLINE ENGINE: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles with 2.0L Gasoline Engine and Turbocharger

Fig 1: Identifying Engine Cover Attachment Points

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the engine cover upward from the attaching points -arrows-. Refer to [For transmission(s) 02E, 02Q] [For engine(s) CVCA, CJAA] Removal and Installation or [For engine(s) CPRA, CPKA, CPLA, CPPA] Removal and Installation or [For engine(s) CVCA] Removal and Installation or [For engine(s) CCTA, CBFA] Removal and Installation or [For engine(s) CBUA] Removal and Installation .

-- Remove the intake hose -2-. Refer to [For engine(s) CCTA, CBFA] Removal and Installation or [For engine(s) CBUA] Removal and Installation or [For engine(s) CPRA, CPKA, CPLA, CPPA] Removal and Installation .

Fig 2: Air Filter, Assembly Over View

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- To do this, loosen clamps -1-.

-- Seal the openings with the Engine Bung Set VAS6122.

Continuation for all vehicles:

-- Remove the noise insulation or impact guard. Refer to Description and Operation .

-- Release and disconnect the connector -1-.

Fig 3: Identifying Brake Lamp Switch

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the screw -2- from the master brake cylinder.

-- Remove the Brake Lamp Switch -- -3- from under the brake master cylinder and from the clip -4-.