Overview - FS III
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Install complete repair kit when servicing.
- Only use mineral spirits to clean brake parts.
- Apply thin coat of Assembly Paste G 052 150 A2 to brake cylinders, pistons and seals.
- 1 -
Dust Cap
- Install onto bleeder valve
- 2 -
Bleeder Valve
- 10 Nm
- Apply a thin coat of Assembly PasteG 052 150 A2 to the threads before screwing in.
- 3 -
Caps
- Insert in bushing
- 4 -
Guide Pin
- 30 Nm
- 5 -
Bearing Bushing
- Insert in brake caliper
- 6 -
Brake Caliper
- Removing and installing. Refer to BRAKE CALIPER, BRAKE CALIPER FS III .
- 7 -
Cap
- Removing and installing. Refer to BRAKE CALIPER PISTON, FS III .
- Do not damage when installing piston
- 8 -
Piston
- Removing and installing. Refer to BRAKE CALIPER PISTON, FS III .
- Apply thin coat of Assembly Paste G 052 150 A2 to piston before inserting
- 9 -
Seal
- Removing and installing. Refer to BRAKE CALIPER PISTON, FS III .