Overview - FN 3

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install complete repair kit when servicing.
Only use mineral spirits to clean brake parts.
Apply thin coat of Assembly Paste -G 052 150 A2- to brake cylinders, pistons and seals.

Fig 1: Exploded View Of FN 3 Front Brake Calipers

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1 -
Dust Cap
- Install onto bleeder valve
2 -
Bleeder Valve
- 10 Nm
- Apply a thin coat of Assembly Paste -G 052 150 A2- to the threads before screwing in.
3 -
Caps
- Insert in bushing
4 -
Guide Pin
- 30 Nm
5 -
Bearing Bushing
- Insert in brake caliper
6 -
Brake Caliper
- Removing and installing. Refer to BRAKE CALIPER, BRAKE CALIPER FN3 .
7 -
Brake Carrier
- Bolt to brake caliper
8 -
Spring
- Insert both ends into the holes in the brake caliper
9 -
Seal
- Removing and installing. Refer to BRAKE CALIPER PISTON, FN 3 .
10 -
Piston
- Removing and installing. Refer to BRAKE CALIPER PISTON, FN 3 .
- Apply thin coat of Assembly Paste -G 052 150 A2- to piston before inserting
11 -
Cap
- Removing and installing. Refer to BRAKE CALIPER PISTON, FN 3 .
- Do not damage when installing piston