ADAPTING Battery Monitoring Control Module -J367-

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

The procedure for "replacing the Battery Monitoring Control Module" includes the following steps:

If a new Battery Monitoring Control Module -J367- is installed in the vehicle, then the Battery Monitoring Control Module -J367- must be coded.
Then the Battery Monitoring Control Module -J367- must be adapted.

The procedure to "replace the Battery Monitoring Control Module" can only be performed Vehicle Diagnostic Tester in the "guided fault finding" function.

Procedure

-- Connect the Vehicle Diagnostic Tester.

-- Select Guided Fault Finding .

-- Use the GO TO button to select the "function/component selection" and the following menu options one after the other:

Body
Electrical System interior/exterior
01 - OBD
61 - Battery regulation
61 - Battery control functions
61 - Replace control module

After the "replace the Battery Monitoring Control Module" procedure occurs, the "starting after replacing" procedure must be performed.

Procedure

-- Connect the Vehicle Diagnostic Tester.

-- Select Guided Fault Finding .

-- Use the GO TO button to select the "function/component selection" and the following menu options one after the other:

Body
Electrical System interior/exterior
01 - OBD
61 - Battery regulation
61 - Battery control functions
61 - Starting after replacing