Transmission To Engine Tightening Specifications

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Tightening Torques, Transmission To Engine (Rabbit/GTI 2006 With 2.5L - 110 kW Engine, Tightening Torques)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1 -
Driving Direction
-
Drive Plate to Torque Converter
- 60 Nm
- Quantity: 6
- Remove and install using the Socket SW 15V/175.
Bolt -
M12
- 80 Nm
- 65 Nm, if using the Insert Tool - 18mm T10179
Bolt -
M10
- 40 Nm
- The bolts are located in the lower flange.
Arrows -
Alignment Sleeves

-- Make sure the bracket does not touch the transmission fluid cooler.

Fig 2: Identifying Selector Lever Cable Retainer And Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-Nuts- : 8 Nm